Roll Forming: WH-Style

WH-200 Driven Roll Stand shown with SPA Feature

Drive Stand Highlights:

  • "C"-washer end shaft arrangement allows removal of outboard housing without complete removal of shaft bolt.
  • Slotted outboard housing allow removal without fully removing holddown bolt.
  • Timken tapered roller bearing in both inboard and outboard bearing boxes.
  • Inboard bearing box does NOT need to be dismantled to set bearing pre-load OR to set shoulder alignment.
  • Common bearing seals used on both inboard and outboard bearing boxes.
  • Shaft keys are bolted to the shaft so they will not fall out and get lost.
  • Single-Point Adjustment (SPA) feature available.

Typical WH-Series Mill Layout Schematic